Some affiliate links are provided below. Learn more.
Learn how to make these simple, neutral fabric acorns – no sewing required.
Other times, I just want something to do while curled up on the couch watching terrible TV shows.
This weekend I was definitely in the latter camp.
So on Saturday afternoon I grabbed my glue gun, donned my ugliest pair of leggings (they may have holes so big I’d be done for public indecency but boy are they comfortable), flopped down on the couch, and made these little fabric acorns.
I got the idea for these acorns after I found a bunch of styrofoam eggs while cleaning out my craft supplies in preparation for our move at the end of the year. I originally bought the eggs for Easter crafts, but there were lots in the bag so I had quite a few leftover. Rather than toss them, I went on Pinterest looking for ways to repurpose them when I came across these DIY acorns by Giustina @ Domestically Blissful (who, funnily enough, also found leftover eggs while cleaning out her craft supplies in preparation for a move).
I loved her general idea, but wanted to make a few changes so that the acorns matched the neutral look I’m kinda going for. Instead of painting the eggs, I decided to cover them in white fabric using a hot glue gun (no sewing, yay). I also wanted a more textured ‘cap’ for my acorns, so I braided the jute twine before sticking it to the egg/acorn.
They’re nothing super flashy, but I think they’re kind of cute!
DIY no-sew fabric scrap acorns
- Foam eggs.
- I don’t remember the exact brand I bought, but they were just basic foam eggs, like these.
- Fabric scraps, cut into rough squares.
- I used drop cloth scrap. Thicker fabric will work best as otherwise the hot glue might seep through and stain it.
- A hot glue gun and glue sticks.
- Jute twine.
- A stick, broken into small bits.
Adding the fabric:
To begin, I put a little bit of hot glue on the narrow end of the egg:
Then pressed it into the middle of the fabric scrap, holding it for a few seconds until the glue set.
Next I added more glue to the sides of the egg and began folding the fabric up and around the egg. I didn’t really follow any particular method, I just kept adding glue until the fabric was nice and secure.
Once the fabric was glued to the egg, I trimmed off the excess using fabric scissors. I did try just leaving it on at first, but found that it made it really hard to add the ‘cap’ to the acorn later on.
Creating the acorn ‘cap’
Next I braided three strands of jute twine. I did take a picture of this step but it turned out super blurry because I’m terrible at blogging. Basically, I just used a standard braid, like the one you would if you were braiding hair.
This step was honestly the longest part of the whole project, so if you’re short on time you can just skip it and add the jute twine to the acorn without braiding it. You could also use a bit of jute ribbon, which has a bit more texture than unbraided twine. I did braids for half of my acorns then used some scrap jute ribbon I had laying around on the rest, as braiding the twine got seriously old after a while.
Once my braid was finished, I used my glue gun to glue the braid to the acorn. I applied a little dot of glue to secure the braid, then started wrapping it around the egg, applying more glue as I went.
Eventually I had something that looked like this:
I then stuck a little bit of a broken twig into the top of the foam. I didn’t bother gluing it as I found the foam kept it in place, but you can always add hot glue to the bottom of the stick if you’re worried.
With the stick in place, I wrapped the rest of the twine around the top to form the acorn “cap”, tucking and gluing the final bit of twine near the stick.
I then repeated the process a few times to make a total of eight fabric acorns.